Costing of Pump setup for borewell

[KVS Setty]

Hello to all,
This is my first post.

I got bore well done for my new house construction recently, bore depth 380ft, total water yield 2.5'' found three sources at different depths.

I have received the following quote for the submersible pump set up, need to know is it ok with the prices or not.

1. Pump Texmo 2HP,25 stages 17,900 +5.5%tax,
2. Panel board 1no 2400
3. HDPE pipe 12.5kg,1.25 inch 89/mt +5.5%tax
4. Nipple Joint 1set 600 +5.5%tax
5. 4sqmm finolex cable 65.00/mt
6.clamp set and cap 400
7.GI acces 380
8.Installation 600
9. transportation 500

when i look at the price of finolex cable it is much lower compared to other quotes from this forum, could this cable is fake/duplicate one?. supplier says it is original one.

your early feed back on this much appreciated.as i need to go for it tomorrow itself.

[sachhi]

Please be careful about finolex wires, as i have heard lot of cases for duplicate material supply.My electrician also insisted to confirm quality before purchase.Best thing to do is to take your electrician to store before purchase and get it tested by him. And offcource, dont go to the store referred by your electrician!! Meenakshi electricals in Vignananagar/New Tippasandra is one firm which delivers genuine quality electricals with no bargain on rate.You can compare the price after getting the quotes for same by them , which would hint you on the quality!!!

-regards
Sachin

[KVS Setty]

@ sachin ,thanks a lot sachin for the advice, yes i do understand that.today i received the material from the supplier he had sent original 2.5 sqmm finolex cable though in the quote it is mentioned as 4sqmm, when i bought this to his notice he said it is a typo and he intended 2.5 sqmm only and it is sufficient for 2hp pump.,however i asked to supply 4sqmm original finolex and the revised price is 89/mt.

got the pump fixed and felt happy when water jets out from the pump, so the first little step of house construction is made with a happy note, paid rs100 as tips the the pump installer.

thanks to all the forum members.

[krkrishnamurthi]

Dear KVS shetty.
Where did you get this quote, it looks reasonable, can u post the contact details, I also received the quote from vinayaka agency he has quoted 20.200 for 2hp texmo make pump..

[sachinbr]

Hello KVS shetty, even I too want the contact detail of the person from whom ur getting it done

[KVS Setty]

Sachin and krishnamurthy , i have sent PM to you.

[sachinbr]

PM replies. plz reply

[sachinbr]

Hey guys after asking quotation from many dealer finally found a reliable.

He has quoted the following.

2HP Texmo 25 Stage, 1 Phase - Rs 19000/-
ISI 12.5KG HDPE pipe- Rs 90 pm
4 sq mm Finolex cables - Rs 93 pm
Panel Board - Rs 2200
SS End fittings - Rs 600
Bore Cap and clamp - Rs500
Installation Charges - Rs1200
Transportation - Rs500
Other bend pipe charges - Rs1100

These are inclusive of taxes.

I feel I have to bargain on installation charges and that bend pipe charges.

Any 1 can better price than this?

[pachik]

Hi KVS Shetty, even I am looking to get a pump installed. Can you share the contact details with me?

Thanks.

[ramki067]

Hi Shetty,

Please PM me too!

Ramki