Thank you Lakshmiji.!lakshmiji wrote:Hello Parthib,
my borewell also similar to the specs you told. dug till 1100 with final source at 1070
the kannan guys have taken me for a ride by not stopping the digging till 1100SFT. as they were not disclosed info properly.
but not to take chance i went till 1100. as all my neighbors got borewells dug till this range...
------------
below are the details of various components and the rates i have got.
check glowship.com for motor
--------
texmo 760H 5HP MOTOR 30500
raksha HDPE 16KGF Pipe 320 meters 320*(121 price varies) 38720
finolex 4SQ MM cable 330 meters 330*(95 price varies) 31350
L&T M6 Starter 5000
Clamps 1200
Transportation 1200
Installation 1200
--------------
there is a borewell camera which gives info where the sources are. go for this test(might cost you 1-2K). get this test done again.
if you post your requirement in indiamart/just dial - sellers will call you. ask for quotation. go with the guy gives best quote
you might need
TEXMO 760H Motor, HDPE Pipes go for raksha(good name in the market), Finolex 4sqmm wire, L&T Starter
while installing take care. ask them to put submersible tape instead of plastic thread to join HDPE Pipe and the Cable....
you might need a TEXMO openwell sump motor of 1.5HP (11345/-)
all the best
Yes, I got checked with Camera person and understood the water level and yield conditions in my borewell by spending 2k.
Next I got three quotes with 2-3k difference. Finally I have gone with NMV engineering, Hoskote as shown below price:
Texmo 750H - 31000
Heritage starter with protection safety - 6000
Mangalam 20Kg HDPE Pipe - (320mx115rs) - 36800
Finolex 4sqmm cable - (335m x 95rs) - 31825
End Joints - 800
Clamps - 1500
Transport and Installation - 3500
Finally they have given 3k discount on total price.
I have got installed 20days back and found the services are very good.
Thanks and Regards,
Parthib