Borewell re-drilling suggestion needed.

[ramki067]

Hi,

We have a borewell which was dug for around 800 ft earlier and while removing for borewell repair, the mud closed down to 300ft. So we had to put the borewell motor upto 300 ft only. We are fully dependent on borewell water for all needs and now we are getting water only for 5 minutes and water stops. We have to ON the motor after around 4 to 5 hours to again get 5 minutes of borewell water.

Hence, i've few queries which i would like to get enlightened with:
1. Do i need to re-drill again till 800 feet which we have previously dug.
2. Do we need to bring in a 30 feet borewell digger for re-drilling or a small 10 feet or so driller is enough for re-drilling? , i'm asking this because we have a roof of the first floor extended/covered on the borewell dug place.
3. For re-drilling, do i need to pay the regular amount for drilling?

Thanks in advance.

Regards,
Ramki

[rajeshkp]

Hi;
Some suggessions.

1)If the yield at 800 ft was good, then you may have to drill.
2)for Qn2 and 3 you have to check with Borewell agency.

But I suspect that your bore well might collapse due to silt accumulation. Even if you drill again silt will fill up. So you may have to use slotted pipes (Very expensive).

[Murthyin]

Hi

Do you need any help with experts contact, please let me know. I can give you a person contact who is very reliable.

Thanks,
Pradeep.K

[vpbs_bak]

pradeep i sent a PM to you

[Murthyin]

You can contact below person. I had a very good bore well drilling experience with him and his company. Issue free,tension free and reliable service.

G. B.H. RAO Mob: 99005 – 82521 Email rao.gbh@gmail.com

He has taken everything and was standing all the time and saved me lot of money.

I recommend this person. You can use my reference.


Thanks,
Pradeep.K