Page 1 of 1
Suggest Submersible pump
Posted: February 17th, 2021, 9:38 pm
by Visualizer
Hi,
Can anyone suggest how much HP pump should I go for to pump water 50 feet high( actual height 45 feet) the depth of sump is 12 feet.
What are the good and economic brands of submersible pumps ?
Regards
Re: Suggest Submersible pump
Posted: February 24th, 2021, 9:29 pm
by ganeshncm
I think for 50 feet you need atleast 1 HP (a lot depends on the bends and curves in the pipe) Single phase.. 3 phase might be helpful if there are plans for expansion
Re: Suggest Submersible pump
Posted: February 24th, 2021, 11:43 pm
by srinihome
I was recommended Texmo Acqua ASM SP 625 1HP for open submersible, by the retailer with whom we purchased Borewell Motor. The Head Range and Discharge Rate are good.
Re: Suggest Submersible pump
Posted: February 25th, 2021, 9:08 am
by Visualizer
Thanks Srini no there won't be any expansion and I am going for single phase domastic connection only.
Re: Suggest Submersible pump
Posted: February 27th, 2021, 11:15 pm
by Visualizer
One important question is submersible pump better than exposed monoblock pump for sump tank.
The sump is 12 feet deep and lift required is 40 feet. The pipe is 1 inch and there will be will be 6 bends.
Re: Suggest Submersible pump
Posted: February 28th, 2021, 4:33 am
by srinihome
Issues with Monoblock:
1. Airlock
2. Noise is high
3. Bearings wear out
4. Low Water Output
Cost-wise Monoblock is cheaper.
You can check
Texmo AQUAGOLD-4
1HP
Total Head M (Ft): 48 (150)
Maximum Discharge LPH: 4000 Ltrs
Discharge LPM @ 15M (40Ft): 60Ltrs