Actual measurement of BDA plots

[msn1270]

Dear yash

There are specific cases, where people have applied for say A x B mtr size and while the carving out the plots from the acquired land, in some cases few plots gets some odd dimension specifically in cases sites coming on border/corner areas which will be specifically mentioned in the sale deed and the differential amount will be taken in case of higher size and refunded in case of lower size. Yours might also similar one.

In one of my relative case also, they had applied for a 9 X12 mtr size and was allotted with a plot size of 30.5 X 42 ft in Nagarabhavi 9th Block, behind Ambedkar College. They were asked to pay for the additional amount before registration. In the same cross other extreme end, the plot size were even more than 30 X 50 or higher higher, But they were allotted for the applicants of 9X12 mtr.

[m3_07]

Friends....Friends....when I say the meter measurement is in 2 decimal points, I mean it....'coz I have 2 bda plots that are intermediate.

[nagsbhat]

Ha Ha Ha!
Yes, I know many intermediate sites in BTM Layout 4 and 6th stages having decimal dimensions. I recently wanted to buy one but the deal did not go through.
Also, in ISRO layout, I know for sure that site measurements have 2 decimal places and if you convert the area in meters to feet, they will match to rounded feets.

[Prashanthhs]

Thanks a lot to everyone for the responses, specially for m3_07 for the attachment. I tried to renegotiate the deal, but it was not fruitful. I had gone very far ahead in the deal to come back or cancel the agreement, so I decided to go ahead with the deal. It was a good and costly learning for me... thanks again to all...

[msn1270]

Prashanthhs

Curious to know, did u measured the size of the plot ?